Dell E665N Instrukcja obsługi - Strona 26

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Serwer Dell E665N. Dell E665N 37 stron. Emc vxrail appliances on poweredge servers
Również dla Dell E665N: Instrukcja instalacji i obsługi (23 strony)

Drukuj stronę

Shared requirements across all categories

Table 30. Shared requirements across all categories

Allowable operations

Maximum temperature gradient (applies to both operation and

nonoperation)

Nonoperational temperature limits

Nonoperational humidity limits

Maximum nonoperational altitude

Maximum operational altitude

*: Per ASHRAE thermal guidelines, these are not instantaneous rates of temperature change.

Table 31. Maximum vibration specifications

Maximum vibration

Operating

Storage

Table 32. Maximum shock pulse specifications

Maximum shock pulse

Operating

Storage

Particulate and gaseous contamination specifications

The following table defines the limitations that help avoid any damages to the IT equipment and/or, or both failure from

particulate and gaseous contamination. If the levels of particulate or gaseous pollution exceed the specified limitations and

results in equipment damage or failure, you must rectify the environmental conditions. Remediation of environmental conditions

is the responsibility of the customer.

Table 33. Particulate contamination specifications

Particulate contamination

Air filtration

Conductive dust

Technical specifications

20°C in an hour* (36°F in an hour) and 5°C in 15 minutes

(9°F in 15 minutes), 5°C in an hour* (9°F in an hour) for tape

hardware

-40°C-65°C (-40°F-149°F)

5% to 95% RH with 27°C (80.6°F) maximum dew point

12,000 meters (39,370 feet)

3,048 meters (10,000 feet)

Specifications

0.26 G

at 5 Hz to 350 Hz (all operation orientations)

rms

1.88 G

at 10 Hz to 500 Hz for 15 minutes (all six sides tested)

rms

Specifications

24 run shock pulses in the positive and negative x, y, and z axis of 6 G for

up to 11 ms. (4 pulse on each side of the system)

Six consecutively run shock pulses in the positive and negative x, y, and z

axis (one pulse on each side of the system) of 71 G for up to 2 ms.

Specifications

Data center air filtration as defined by ISO Class 8 per ISO

14644-1 with a 95% upper confidence limit.

NOTE:

only. Air filtration requirements do not apply to IT

equipment designed to be used outside a data center, in

environments such as an office or factory floor.

NOTE:

MERV13 filtration.

NOTE:

room air with MERV8 filter per ANSI/ASHARE Standard

127.

Air must be free of conductive dust, zinc whiskers, or other

conductive particles.

This condition applies to data center environments

Air entering the data center must have MERV11 or

Air filtering can also be accomplished by filtering