Chris King R45 DISC Podręcznik użytkownika - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria rowerowe Chris King R45 DISC. Chris King R45 DISC 16 stron. Hub
Również dla Chris King R45 DISC: Podręcznik (20 strony)
Drukuj stronę
Disassembly of front R45 and R45 Disc hub
1. Insert 5 mm hex wrenches into both ends of axle assembly.
2. Hold right hand stationary and turn left hand counterclockwise 1/4 turn until assembly is loose.
3. Loosen and unscrew adjusting cone and axle end until they are free from main axle.
4. Slide out main axle.
5. Both hub shell bearing assemblies can now be accessed.
For bearing service information see "Service of the bearings", pg. 8.
Reassembly of front R45 and R45 Disc Hub
1. Lightly grease threads on axle, adjusting cone and axle end. Apply t wo drops of lightweight,
low viscosity oil, with PTFE ( e.g. TriFlow
2. Insert main axle into hub shell.
3. I f a x l e e n d a n d a d j u s t i n g c o n e a r e a s s e m b l e d a s o n e u n i t , d i s a s s e m b l e b y t h r e a d i n g a x l e
end out of adjusting cone and apply a thin layer of waterproof grease to the threads.
4. Thread adjusting cone onto the protruding threads of main axle.
5. Lightly snug adjusting cone up to bearing.
6. Thread axle end into adjusting cone until it stops.
7. Proceed to "Adjustment of two piece axle on front R45 & R45 Disc", next.
Adjustment of two piece axle on front R45 and R45 Disc
Hub
(see Figure 3)
1. Insert 5 mm hex wrenches into both ends of axle assembly.
2. Hold right hand stationary and turn left hand counterclockwise 1/4 turn until assembly is loose.
3. Hold hex wrenches stationary and adjust bearing preload with adjusting cone.
4. A d v a n c e a d j u s t i n g c o n e u n t i l i t j u s t c o n t a c t s b e a r i n g , t h e n b a c k o f f a p p r o x i m a t e l y 1 / 1 6
B.
A. R45 and R45 Disc hubshell assembly
B. R45 axle and R45 Disc front axle
C. R45 adjusting cone
D. R45 axle end and R45 Disc axle end
* R45 and R45 Disc hubshells, axles, and axle
ends are not cross compatible
Figure 3
) to axle O-rings.
™
(see Figure 3)
A.
C.
(see Figure 3)
D.
5