Dell EMC PowerProtect DD6400 System Instrukcje rozbudowy - Strona 33

Przeglądaj online lub pobierz pdf Instrukcje rozbudowy dla Serwer Dell EMC PowerProtect DD6400 System. Dell EMC PowerProtect DD6400 System 46 stron.

Change the iDRAC network port

About this task

iDRAC provides the ability to disable the dedicated iDRAC Ethernet port and assign the iDRAC connection to share one of the

network daughter card Ethernet ports. This step is optional.

Steps

1. Connect to the system serial console or connect KVM to the system.

2. Reboot the system.

3. During the system boot process, press F2 to access the BIOS menu.

4. Select iDRAC Settings.

5. Select Network.

6. Under Network Settings, change NIC Selection from Dedicated to one of the following values:

Table 7. iDRAC NIC to physical port mapping

iDRAC NIC selection

LOM1 - [NIC Integrated 1-1-1]

LOM2 - [NIC Integrated 1-2-1]

LOM3 - [NIC Integrated 1-3-1]

LOM4 - [NIC Integrated 1-4-1]

7. Press Esc to return to the previous menu.

8. Exit the BIOS menu and reboot the system to allow the change to take effect.

For HA pairs, administrative communication must be enabled on both nodes.

The serial port and dedicated iDRAC9 dedicated management port at the rear of the system are the only supported interfaces

for console access. Do not connect to the USB and iDRAC direct micro-USB port on the front of the system.

Use the following settings:

Table 8. Communications settings

Setting

Baud rate

Data bits

Stop bits

Parity

Flow control

Physical network port

Network daughter card port 1

Network daughter card port 2

Network daughter card port 3

Network daughter card port 4

Value

115200

None

Configure System for Use