Dell Force10 S2410 Skrócona instrukcja obsługi - Strona 20
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Serwer Dell Force10 S2410. Dell Force10 S2410 31 stron. Installing the s2410 system
Również dla Dell Force10 S2410: Podręcznik (42 strony)
Drukuj stronęConfigure a Host Name
If you have more than one individually managed S-Series switch, you can
differentiate them by creating a unique CLI host name prompt for each switch.
Use the hostname command, in Global Config mode, to edit the prompt. The
host name is case-sensitive and can be up to 64 characters in length.
Task
Create a new host name
Access the System Remotely
Configure the Management Port IP Address
On first startup, you have management access only through the console port. If
you want to manage the switch through an IP-based access method (Telnet,
SSH, SNMP, TFTP, etc.), you must configure a management IP interface, using
the following the procedure.
Step Task
Display current management IP
1
configuration.
Set the IP gateway of the
2
management interface.
Invoke the (Config-if-ma)#
3
prompt.
Set the IP address and subnet
4
mask of the management
interface.
NOTE: Creating a management IP address is supported by both the Layer 2
(Switching) and Layer 3 (Routing) licenses of SFTOS.
By default, the management address is reachable from all ports on the default
VLAN, VLAN 1. One or more ports in that VLAN must be enabled.
16
Installing the Software
Command Syntax
hostname name
Command Syntax
show interface
managementethernet
management route default
gateway
interface
managementethernet
ip address ipaddr
subnetmask
Command Mode
Global Config
Command Mode
User Exec or
Privileged Exec
Global Config
Global Config
(Config-if-ma)#
prompt within the
Global Config
mode