Dell PowerEdge 2550 Instrukcja instalacji stojaka - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji stojaka dla Serwer Dell PowerEdge 2550. Dell PowerEdge 2550 40 stron. Wake-on-lan (wol) support on dell servers
Również dla Dell PowerEdge 2550: Instrukcja instalacji (26 strony), Instrukcja instalacji (32 strony), Podręcznik konfiguracji (10 strony), Instrukcja aktywacji (32 strony), Instrukcja instalacji (32 strony), Podręcznik (28 strony), Podręcznik (15 strony)

Recommended Tools and Supplies

You need the following tools and supplies to install the system in a two-post,

open-frame relay rack:

•

#2 Phillips screwdriver

•

Masking tape or felt-tip marker pen to mark the mounting holes

Installing a two-post rack kit includes the following tasks:

Flush mount installation

Center mount installation

Marking the Rack

Determine where you want to place the bottom of the support tray.

If you are installing other components in the rack, install the heaviest items at the

bottom of the rack.

Place the 2-U template over the front of the rack rails in the desired location.

Position the bottom of the template in line with the desired bottom position of the

system chassis.

NOTE: If your rack has wide-hole spacing, go to step 5. If your rack has universal-hole spacing,

continue with the next step.

Mark the upper- and lower-mounting positions on the vertical rails as shown by the

bottom and top V-notches on the sides of the template.

Each 1-U (1.75-inch) vertical space on a rack with universal-hole spacing has three

holes with center-to-center spacing between holes (beginning at the top of a

1-U space) of 0.625, 0.625, and 0.5 inches (see Figure 1-2).

Ra c k In s ta l lati on Gui de

1-3