Dell PowerEdge 5160 Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Serwer Dell PowerEdge 5160. Dell PowerEdge 5160 42 stron. Installing the external drive bay
Również dla Dell PowerEdge 5160: Instrukcja instalacji (42 strony), Instrukcja instalacji (20 strony), Instrukcja instalacji (28 strony), Aktualizacja instrukcji (8 strony), Aktualizacja informacji (8 strony), Instalacja stojaka (34 strony), Instrukcja instalacji sprzętu (40 strony), Instrukcja instalacji (36 strony)

Dell™ PowerEdge™6300

and 4x00 Systems

SCSI Backplane Option

This document describes the optional small computer system interface (SCSI) back-

plane for the Dell PowerEdge 6300 and 4x00 systems.

The 1 x 8 SCSI backplane provides hot-pluggable Ultra2/LVD SCSI connections for up

to eight 1-inch hard-disk drives in the system's internal drive compartment. Except for

the added SCSI connections provided on the board, the 1 x 8 backplane is identical to

the 1 x 6 backplane in features and functionality (for example, the cable connectors on

both backplanes are identical). For a description of the SCSI backplane, refer to your

system User's Guide and Installation and Troubleshooting Guide.

NOTE: Before you install the 1 x 8 backplane, verify that your system chassis supports

it. Check the back of your system for a label (located between the connectors and the

first power supply) that specifies that your chassis supports the 1 x 8 backplane. If you

do not find a label, you may not be able to use the 1 x 8 backplane in your system

chassis. Contact your Dell representative for further information and instructions.

Installing a SCSI Backplane

WARNING: The power supplies in this computer system produce high volt-

ages and energy hazards, which can cause bodily harm. Only trained

service technicians are authorized to remove the computer cover and

access any of the components inside the computer.

NOTE: You can use only 1-inch hard-disk drives with the 1 x 8 backplane. You

cannot use 1.6-inch hard-disk drives with the 1 x 8 backplane. To work with the

1 x 8 backplane, you need to convert the drive carriers to the 1-inch width by removing

the spacer insert that fastens to each carrier adjacent to the carrier release handle.

To replace a SCSI backplane board with a different backplane board, perform the fol-

lowing steps.

support.dell.com

Dell PowerEdge 6300 and 4x00 Systems SCSI Backplane Option

1-1