Dell PowerEdge 860 Instrukcja serwisowa - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Serwer Dell PowerEdge 860. Dell PowerEdge 860 37 stron. Sas/raid controller installation
Również dla Dell PowerEdge 860: Aktualizacja informacji (14 strony), Instrukcja instalacji (28 strony), Instrukcja instalacji (7 strony)

Drukuj stronę
Dell PowerEdge 860 Instrukcja serwisowa
Back to Contents Page
  Processor Heat Sink
Dell™ Vostro™ A840/A860 Service Manual 
  Removing the Processor Heat Sink
  Replacing the Processor Heat Sink
 
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance
 
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
 Removing the Processor Heat Sink
 
1. Follow the instructions in
Before You
 
2. Remove the system board (see
 
3. Turn the system board over.
 
4. Loosen the four captive screws on the processor heat sink.
 
5. Lift the processor heat sink out of the computer.
1
processor heat sink
 Replacing the Processor Heat Sink
NOTE:
The original thermal pad can be reused if the original processor and processor heat sink are reinstalled together. If either the processor or the
processor heat sink is replaced, use the thermal pad provided in the kit to ensure that thermal conductivity is achieved.
NOTE:
This procedure assumes that you have already removed the processor heat sink and are ready to replace it.
 
1. Peel the backing off the thermal pad and adhere the pad to the portion of the processor heat sink assembly that covers the processor.
 
2. Slide the processor heat sink under the bracket and align the four captive screws with the screw holes on the system board.
 
3. Tighten the four captive screws.
 
4. Follow the instructions in
Replacing the System
Back to Contents Page
 
Begin.
Removing the System
Board).
2
captive screw (4)
Board.