Avue AU-G50L-WB26 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kamera bezpieczeństwa Avue AU-G50L-WB26. Avue AU-G50L-WB26 17 stron. High-speed outdoor ptz camera series

Drukuj stronę

OPERATION

Powering the PTZ

Work with PTZ

In order to work with the PTZ function, you need a device for telemetric control, such as a controller keyboard, a PTZ software or DVR with PTZ control.

Make sure that the protocol, baud-rate setting are done correctly as described in section "Installation", or refer to the operation manual of the controller

device.

Beside the pan, tilt and zoom function, this camera provides also auxiliary function for surveillance, such as preset position, self-learning tours and

pattern, which consist the more preset position. The setting of camera and auxiliary function can be accessed either directly from the keyboard, or

through the On-Screen-Display ( OSD) menu, a text-based navigation menu projected on the monitor screen.

PAN, TILT and ZOOM Functions

In order to work with the PTZ function, you need a device for telemetric control, such as a controller keyboard, a PTZ software or DVR with PTZ

control. Make sure that your controller device supports these functions.

Zoom in

Zoom out

IRIS and FOCUS

In regular operation, the focus and iris will be regulated automatically to achieve best image quality. If case of need, you can adjust Iris and focus

setting by press the corresponding buttons on the controller device. The auto-focus will resume once a PTZ command is triggered.

IRIS Close

IRIS Open

Auxiliary Function

The auxiliary function provides user automated action, such as memorizing position and recalling by a direct input on the cotnroller device. Make

sure that the keyboard controller you use support these function, and refer to the manual for operation.

PRESET: A Pan-Tilt position which contains the zoom

setting. Up to 128 presets can be stored in the camera

Preset 1

Preset 2

PATTERN TOUR: A recording of user's Pan, Tilt and

zoom up to 180 seconds. Up to 4 pattern tours are

supported

Camera Functions

This PTZ camera provides also image enhancement functions, such as BLC, AGC, AE or the Day/Night Vision. Details will be introducece in the

section "OSD".

After connected to power source, the PTZ will perform the self-test with pan, tilt and zoom, and

displays the initial screen with following information:

S/N: Serial number of the PTZ

FIRMWARE: Current firmware version

PROTOCOL: Protocol version

DOME ADDRESS: the PTZ ID

COMM: Baud-rate and serial settings

The initial screen will disappear once the PTZ camera receives a user command. If the function

"Power up action" is defined with certain action, it will execute the action immediately.

PAN

TILT

FOCUS

Far

Near

Preset 4

Preset 3

SEQUENCE(PRESET TOUR): An auto-touring thourgh the defined,

stored preset positions. Each tour can contain up to 24 preset points.

Total 4 tours can be stored in the camera.

Preset 4

Preset X

Preset 3

Preset 1

Preset 2

SCAN TOUR: A Pan-Tilt moving between 2 defined limits. Up to 4 scan

tours are supported

Right Limit

Left Limit

English

The PAN and TILT function are mostly

performed from the Joystick on the keyboard.

Please refer to the user's manual of contoller

device for operation instruction