2xWireless 2X Instrukcja obsługi i instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Router bezprzewodowy 2xWireless 2X. 2xWireless 2X 12 stron. Gen6 cpe

Final assembly

5. Bolt the reflector and radio assembly to the mounting bracket assembly with the remaining four

1" long ¼"-20 carriage bolts and the four Serrated flange nuts. Tighten the nuts ¼ turn past

snug. Note: The cable entry port must be facing down to prevent water from entering the

device. Improper installation will cause water damage and void the warranty.

Installation and adjustment

6. Place assembly with bracket against pole and slide the two steel tooth brackets onto the V bolts

as shown. For proper installation, the larger end of bracket A should be on the bottom and the

cable entry point should be pointing down. The brackets are held in place with (4) flat washers,

(4) split lock washers and (4) ¼"-20 hex nuts. Finger tighten at this time to allow azimuth

adjustment of the CPE on the mounting pole during alignment.