Dell PowerEdge 4400 Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przechowywanie Dell PowerEdge 4400. Dell PowerEdge 4400 28 stron. Wake-on-lan (wol) support on dell servers
Również dla Dell PowerEdge 4400: Instrukcja instalacji (42 strony), Instrukcja instalacji (20 strony), Instalacja stojaka (37 strony), Aktualizacja instrukcji (8 strony), Aktualizacja informacji (8 strony), Podręcznik użytkownika (42 strony), Instalacja stojaka (34 strony), Instrukcja instalacji sprzętu (40 strony), Instrukcja instalacji (36 strony), Podręcznik (15 strony)

support.dell.com

WARNING: Never pull more than one system out of the rack on its slide

assemblies at one time. The weight of more than one extended system

could cause the rack to tip over and injure someone.

The stabilizer feet help prevent the possibility of the rack tipping over when a

system or other components are pulled out of the rack far enough so that the slide

assemblies are fully extended. Refer to the Dell PowerEdge Rack-Mountable

Solutions Installation Guide provided with the rack for instructions on installing the

stabilizer feet.

Recommended Tools

To install the tower kit, you need the following tools:

•

A #2 Phillips screwdriver

•

A flat-blade screwdriver

To install a tower kit, perform these steps (see the following subsections for detailed

instructions):

Shut down and turn off the system.

Remove the rack's front and rear doors.

Remove the cable management arm.

Remove the cable tray.

Remove the system from the rack.

Replace the rack doors.

7 .

Install the rubber feet.

Remove the front bezel.

Reorient the drives.

10. Reorient the system badge.

11. Replace the front bezel.

12. Attach the cables and turn the system on.

It is usually best to perform this installation at a time when there are no users on the

system. Shut down all application programs running on the server and turn off the

system.

Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide

1-3