Dell PowerEdge SC420 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przechowywanie Dell PowerEdge SC420. Dell PowerEdge SC420 21 stron. Expansion enclosure
Również dla Dell PowerEdge SC420: Instrukcja wymiany (14 strony), Instrukcja obsługi (26 strony), Podręcznik dla początkujących (7 strony), Aktualizacja informacji (21 strony)

Hard drive carrier

Press the release button on the replacement hard drive to open the hard drive carrier release handle.

NOTE: Hold the hard drive by the plastic part of the hard drive carrier or the handle.

Insert the hard drive carrier into the hard drive slot until the carrier make contact with the backplane.

CAUTION: Do not remove the hard drive blanks that are installed in hard drive slots that are not occupied. The hard

drive blanks ensure proper cooling of the expansion enclosure.

Close the hard drive carrier handle to lock the hard drive in place.

NOTE: Allow several seconds for the expansion enclosure to recognize the hard drive and determine its status.

Replace the front bezel.

In Storage Manager, make sure that the replacement hard drive is recognized and shown as up and healthy.

Next step

Use SupportAssist to send diagnostic data to Dell Technical Support Services.

Installing Hard Drives in an SC400 Series Expansion Enclosure

An SC400 series expansion enclosure is shipped with drives installed and empty drive blanks are inserted in the unused slots.

About this task

The following instructions describe the installation of Dell Enterprise hard drives for reference only.

Steps

Open the hard drive carrier handle and insert the hard drive carrier into the hard drive slot.

Start on the left side of the expansion enclosure with slot 0 and install drives from left to right.

Slide the drive into the slot until the hard drive carrier contacts the backplane.

Figure 12. Installing Dell Enterprise Hard Drives in an SC400

Replacing SC400 Series Expansion Enclosure Components

Hard drive slot