Dell PowerVault 755N Pierwsze kroki - Strona 8

Przeglądaj online lub pobierz pdf Pierwsze kroki dla Przechowywanie Dell PowerVault 755N. Dell PowerVault 755N 10 stron. Installing microsoft updates and service packs
Również dla Dell PowerVault 755N: Instrukcja obsługi platformy (40 strony), Aktualizacja instrukcji (10 strony)

Drukuj stronę

Using a Serial Connection

Use this method only if you want to access the NAS Manager without using DHCP or the

Kick-Start utility. Your NAS appliance is configured to provide an IP connection through

the serial port.

To configure your system using the serial port, you must connect a client system to serial

port 1 on the NAS appliance, configure the client system to allow the use of the

communications cable between two systems, and use the Web browser on the client system

to access the NAS Manager. Next, use the NAS Manager to configure your system and

network information.

For complete instructions about configuring your system with the serial connection, see the

"Introduction" section of the System Administrator's Guide that came with the appliance.

Phase Three: Using the NAS Appliance

At this point in the process, you should be able to begin using your NAS appliance with its

default configuration and begin configuring it for use in your specific environment. You

might need to add shares, perform system administration, and configure your storage.

Using the Default Share

To help you get up and running quickly, your NAS appliance provides a default share. You

can use this share immediately, and then create additional shares for specific purposes as

you need them. Because the share does not have any restricted permissions (by default), it is

open to all users of the system. The default share is configured to support both Windows

(CIFS) and UNIX

(NFS). For both Windows and UNIX, the share name is Share, and it is

located at E:\Share. For information about managing your shares, see the "NAS Manager"

section in the System Administrator's Guide that came with the appliance.

Performing System Administration

To add users and groups, join a domain, add shares, or perform other administrative tasks,

connect to the NAS Manager. For detailed information, see the "Introduction" and "NAS

Manager" sections in the System Administrator's Guide that came with the appliance.

Connect to the NAS appliance from your client system by entering the system name of the

NAS appliance in the Microsoft

Internet Explorer 5.0 or later (or for Red Hat Linux only,

use Netscape Navigator 6.1 or later) Web browser.

1-6

Us i n g Yo u r A p pl i a n c e fo r t he Fi rs t T i m e