Dell PowerVault MD2460 Instrukcja obsługi - Strona 39

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przechowywanie Dell PowerVault MD2460. Dell PowerVault MD2460 47 stron. Direct-attach storage for poweredge servers

Drukuj stronę

Figure 36. Disconnect the power cable

3. Loosen the thumbscrew that attaches the PSU to the chassis.

4. Pull down on the orange tab to rotate the handle downward and release the PSU from its seated position.

5. Gently pull the PSU out of the enclosure with one hand and the other hand supporting its weight.

Ensure that the PSU remains level while removing it from the enclosure.

Figure 37. Remove the PSU

Install the PSU

Perform the following steps to install the PSU in an enclosure:

Steps

1. Hold the PSU handle in the open position and use one hand to support the weight of the PSU and the other hand to guide it

into the empty slot.

2. Push the PSU into the chassis until it stops. Ensure that the PSU remains level.

3. Push the orange tab to rotate the PSU handle upwards to the closed position.

Replacing components