Dell PowerVault TL4000 Pierwsze kroki - Strona 25

Przeglądaj online lub pobierz pdf Pierwsze kroki dla Przechowywanie Dell PowerVault TL4000. Dell PowerVault TL4000 38 stron. Tape library
Również dla Dell PowerVault TL4000: Informacje o wersji (3 strony), Faq (26 strony), Skrócona instrukcja obsługi (7 strony), Instrukcja oprogramowania (16 strony), Podręcznik konfiguracji (22 strony), Podręcznik zawierający ważne informacje (10 strony), Dodatek do instrukcji obsługi (2 strony), Podręcznik dla początkujących (3 strony), Instrukcje dotyczące załączników (17 strony), Broszura (4 strony), Podręcznik użytkownika (20 strony)

In a fully populated 4U library with full high drives and two logical libraries,

resource assignments will be as follows:

v Logical Library 1 will contain Drive 1 and the left cartridge magazines.

v Logical Library 2 will contain Drive 2 and the right cartridge magazines.

The I/O Station and slots reserved for cleaning cartridges, if any, are shared among

all logical libraries.

1. Navigate to Configure Library → Logical Libraries using the Web User

Figure 1-17. The 4U library Configure Library: Logical Libraries page

2. Select the number of logical libraries you would like to create in your library.

3. Click Submit to create the logical libraries.

Choosing Library Settings

If your library contains only one logical library, both general and specific settings

will be combined into one table (see Figure 1-18 on page 1-16).

1. Expand Configure Library in the left navigation pane of the Web User

2. Click General and enter the following:

Note: For more information about various configurations, see Fig 1.x on page

x.x

Interface.

v Library Name - Enter a name for your library. A maximum of 8 characters is

allowed.

v Library Mode (per logical library):

– Random: In random mode, the library allows the server's (host's)

application software to select any data cartridge in any order.

– Sequential: In sequential mode, the library's firmware predefines the

selection of the cartridges. After initialization, the firmware causes the

library to select the first available cartridge found (counting from the I/O

Station through the last slot in your library) for loading into the drive.

- Autoload: Sequential mode with autoload mode ON loads the first

available cartridge (slot with the lowest numerical value that contains a

cartridge) automatically if the library powers ON with an empty drive.

- Loop: Sequential mode with loop mode ON loads the cartridge in the

lowest numerical slot after the cartridge in the highest numerical slot

has been filled and sent back to its home slot. This allows endless

backup operations without user interaction.

v Active Slots - Select the number of active slots you would like to assign in

your library. This item will affect the number of Res. (Reserved) Slots in

your library.

1-15

Installation