Dell SCv2080 Instrukcja obsługi - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przechowywanie Dell SCv2080. Dell SCv2080 49 stron. Storage center
Również dla Dell SCv2080: Podręcznik dla początkujących (24 strony), Podręcznik dla początkujących (23 strony), Instrukcja obsługi (45 strony)
Drukuj stronę
Item Control/Feature
4
REPL port (Slot 3/Port 2) —
5
SAS activity indicators
6
Storage controller status
7
Recessed power off
button
8
Storage controller fault
9
Recessed reset button
10
Identification LED
11
USB port
12
Diagnostic LEDs (8)
13
Serial port (3.5 mm mini
jack)
14
Two options:
•
Four Fibre Channel
ports (Slot 1/Port 1,
Slot 1/Port 2, Slot 1/
Port 3, and Slot 1/
Port 4) with three
LEDs per port
•
Two Fibre Channel
ports (Slot 1/Port 1
and Slot 1/Port 2)
with three LEDs per
port
12
Icon Description
NOTE: To use the MGMT port as an iSCSI port for
replication to another Storage Center, a Flex Port license
and replication license are required. To use the MGMT port
as a front-end connection to host servers, a Flex Port
license is required.
Ethernet/iSCSI port that is typically used for replication to
another Storage Center (requires a replication license)
NOTE: To use the RELP port as a front-end connection to
host servers, a Flex Port license is required.
—
There are four SAS PHYs per SAS port.
•
Off: SAS PHY is not connected
•
Steady green: SAS PHY is connected, but not active
•
Blinking green: SAS PHY is not connected nor active
On: Storage controller completed POST
Not currently used
•
Off: No faults
•
Steady amber: Firmware has detected an error
•
Blinking amber: Storage controller is performing POST
Not currently used
•
Off: Identification disabled
•
Blinking blue (for 15 sec.): Identification is enabled
•
Blinking blue (continuously): Storage controller shut down
to the Advanced Configuration and Power Interface (ACPI)
S5 state
One USB 3.0 connector
—
•
Green LEDs 0–3: Low byte hex POST code
•
Green LEDs 4–7: High byte hex POST code
Not for customer use
—
LEDs for the four 8 Gb Fibre Channel ports:
•
All off: No power
•
All on: Booting up
•
Blinking amber: 2 Gbps activity
•
Blinking green: 4 Gbps activity
•
Blinking yellow: 8 Gbps activity
•
Blinking amber and yellow: Beacon
•
All blinking (simultaneous): Firmware initialized
•
All blinking (alternating): Firmware fault
LEDs for the two 16 Gb Fibre Channel ports:
About the SCv2080 Storage System