Dell VxRail E660 Instrukcja instalacji i obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Przechowywanie Dell VxRail E660. Dell VxRail E660 32 stron.
Również dla Dell VxRail E660: Instrukcja instalacji i obsługi (32 strony)
Drukuj stronę
Item
Ports, panels, or slots
11
OCP NIC port
12
NIC port (2)
For more information, see the Dell VxRail E660, E660F, and E660N Technical Specifications.
The following figure shows the rear view of VxRail E660, E660F, and E660N with 3 x LP PCIe slots:
Item
Ports, panels, or slots
1
Power supply unit (PSU
1)
2
PCIe expansion card riser
(slot 1)
3
PCIe expansion card riser
(slot 2)
4
USB 2.0 port (1)
5
PCIe expansion card riser
(slot 3)
6
Power supply unit (PSU
2)
7
VGA port (on STD RIO
board)
8
USB 3.0 port (1)
9
iDRAC dedicated port
10
System identification
button
Icon
N/A
Icon
N/A
N/A
N/A
Description
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
● If the system stops responding during POST, press
and hold the system ID button (for more than 5
seconds) to enter the BIOS progress mode.
This port supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
The NIC ports are embedded on the LOM card that is
connected to the system board.
Description
Indicates the PSU.
The expansion card riser enables you to connect PCI
Express expansion cards.
The expansion card riser enables you to connect PCI
Express expansion cards.
This port is USB 2.0-compliant.
The expansion card riser enables you to connect PCI
Express expansion cards.
Indicates the PSU.
Enables you to connect a display device to the system.
This port is USB 3.0-compliant.
Enables you to remotely access iDRAC.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
System overview
9