Dell EMC PowerSwitch S6100-ON Instrukcja instalacji - Strona 45

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik Dell EMC PowerSwitch S6100-ON. Dell EMC PowerSwitch S6100-ON 48 stron.

Agency compliance

The S6100–ON is designed to comply with the following safety and agency requirements.

USA Federal Communications Commission (FCC)

statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC

rules. These limits are designated to provide reasonable protection against harmful interference when the equipment is operated

in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and

used in accordance to the instructions, it may cause harmful interference to radio communications. Operation of this equipment

in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures

necessary to correct the interference at their own expense.

Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell is not responsible

for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized

changes or modifications in the equipment. Unauthorized changes or modification could void the user's authority to operate the

equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation.

Figure 32. Canadian Department of Communication statement

European Union EMC Directive Conformance

statement

This product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on the approximation of

the laws of the Member States relating to electromagnetic compatibility. Dell Networking can not accept responsibility for any

failure to satisfy the protection requirements resulting from a non-recommended modification of this product, including the

fitting of non-Dell Networking option cards.

This product has been tested and found to comply with the limits for Class A Information Technology Equipment according

to CISPR 22/European Standard EN 55022. The limits for Class A equipment were derived for commercial and industrial

environments to provide reasonable protection against interference with licensed communication equipment.

NOTE:

This is a Class A product. In a domestic environment, this device may cause radio interference, in which case, you

may be required to take adequate measures.

European Community Contact

Dell Networking, EMEA - Central

Dahlienweg 19

66265 Heusweiler

Germany

http://www.force10networks.com/german/

Tel: +49 172 6802630

Email: EMEA Central Sales

Specifications