Dell Force10 MXL 10 GbE Podręcznik dla początkujących - Strona 27
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Przełącznik Dell Force10 MXL 10 GbE. Dell Force10 MXL 10 GbE 38 stron. 10/40gbe blade switches
Również dla Dell Force10 MXL 10 GbE: Podręcznik (27 strony)
Drukuj stronę
lower 40GbE base-module port and
for the upper 40GbE base-module port. To display the ports in each stack
group, enter the
2 Save the stacking configuration on the 40GbE ports:
FTOS# write memory
3 Repeat Steps 1 and 2 on each MXL 10/40GbE Switch in the stack by
entering the
stack-unit 0 stack-group 0
commands and saving the configuration.
4 Reboot each switch by entering the reload command in EXEC Privilege
mode:
FTOS# reload
If the stacked switches all reboot at approximately the same time, the
switch with the highest MAC address is automatically elected as the
Master Switch. The switch with the next highest MAC address is elected
as Standby Master.
To configure the stack so that the roles are assigned according to
pre-determined priorities, enter the stack-unit priority command as
described in the Note below.
To reload the stack, connect the terminal to the Master Switch and enter the
reload command in EXEC Privilege mode. If you connect the terminal to a
member (non-Master) switch, you will not be able to access the CLI.
To determine which switch is the Stack Master, enter the show system
command at the terminal.
To remove a port from stacking mode, use the no form of the
command; for example,
group
command, save the configuration and reload the switch for the change to take
effect. When the reload completes, the port comes up in 40GbE mode if it is
on the base module and in 4x10GbE (quad) mode if the port is on a plug-in
module.
NOTE:
You can also manually configure the switch that will be master by entering
unit-number
the stack-unit
each stacked switch, where:
unit-number
stack-unit
number
priority
specifies the management priority. Range: 1-14. Default: 0.
The switch with the highest priority number is elected Master. The switch with the
next highest priority number is elected Standby Master and takes over stack
stack-group 1
show system stack-unit
no stack-unit 0 stack-group 0
number
priority
identifies the switch in the stack.
defines the stack group
unit-number
stack-group
and
stack-unit 0 stack-group 1
. After entering the
command in CONFIGURATION mode on
Assembling a Switch Stack
command.
stack-unit stack-
27