Dell Force10 S50V Series Skrócona instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przełącznik Dell Force10 S50V Series. Dell Force10 S50V Series 25 stron. Switches

You must provide your own cables to connect to the power source. Cables must

be sized for 11.5 A service at no more than -48VDC input (per NEC in the

United States; internationally, follow local safety codes.).

Connect the grounding cable to the FG terminal first, then connect the opposite

end to the appropriate grounding point at your site to ensure an adequate chassis

ground.

Install the SFP and XFP Optics

The S50N and S50V each have four receptacles at the right end of their

faceplates that accommodate 10/100/1000 SFP optical transceivers.

A 10GbE module contains two ports. 10GbE modules should only be inserted or

removed when the switch is powered down. Refer to the

guide for information related to optional module installation.

Systems

SFP and XFP transceivers can be inserted or removed while the switch is

running.

CAUTION: Before connecting a transceiver to a source, check the receive

power of the transceiver with an optical power meter. Generally, Dell Force10

specified optics are not to be subjected to receive power higher than that

stipulated by the optic specification. If the optic is exposed to optical power in

excess of the specification, there is a high likelihood that it will be damaged.

CAUTION: Electrostatic discharge (ESD) damage can occur if components

are mishandled. Always wear an ESD-preventive wrist or heel ground strap

when handling the chassis and its components.

WARNING: Follow all warning labels when working with optical fibers.

Always wear eye protection when working with optical fibers. Never look

directly into the end of a terminated or unterminated fiber or connector as it

may cause eye damage.

Step

Task

Position the SFP or XFP so it is in the upright position. (The SFP optic

has a key that prevents it from being inserted incorrectly.).

Insert the optic into the port until it gently snaps into place.

Installing S50N and S50V

Installing the Hardware