Dell MXG610s Instrukcja konfiguracji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Przełącznik Dell MXG610s. Dell MXG610s 13 stron. Fibre channel switch module
Również dla Dell MXG610s: Instrukcja konfiguracji (17 strony)
Drukuj stronę1. PowerEdge MX7000 chassis back view.
2. Switch module slot C2
3. Switch module slot C1
2. Orient the switch module port side facing you.
The module latch is on the right side.
1. Backplane connectors
2. Switch module top view.
3. Switch module latch in the open position.
3. Open the release lever, and slide the switch module into the slot completely.
You hear a click when the switch module is locked into the I/O module bay. If power is applied to the MX7000, locking the
switch module in the module bay powers on the switch.
When you apply power, the switch module runs POSTs which may take up to two minutes to complete. After the power/
status LED light is steady green for at least two minutes, the module is ready to use.
4. Start from port 0, then port 17, and then the rest of the ports when cabling the SFP+ ports.
You are now ready to insert more SFP+/QSFP optical transceivers, if needed. Be sure to use only Brocade-branded SFP+/QSFP
optical transceivers. The MXG610s does not recognize non-Broadcom products.
Serial connection
To log in to the switch module through the serial connection on the front panel, perform the following steps:
1. Connect the console cable with the micro-USB connector to the console port on the switch module and to a USB port on
the workstation.
6
MXG610s Setup Guide