Dell Networking S4810 Podręcznik konfiguracji - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik konfiguracji dla Przełącznik Dell Networking S4810. Dell Networking S4810 17 stron. Open networking
Również dla Dell Networking S4810: Specyfikacje (2 strony), Podręcznik konfiguracji (17 strony), Instrukcja instalacji (42 strony), Podręcznik dla początkujących (16 strony)

Dell recommended switch configuration

These steps show you how to configure two S4810 switches with a Link Aggregation Group (LAG). The

switches are interconnected using two of the 40 GbE Quad Small Form-factor Pluggable (QSFP) uplink

ports, and the LAG is configured for Dynamic Link Aggregation Control Protocol (LACP).

2.1

Power on the two switches.

2. Connect a serial cable to the serial port of the first switch.

3. Using Putty or another terminal utility, open a serial connection session to the switch.

4. Open your terminal emulator and configure it to use the serial port (usually COM1 but this may

vary depending on your system). Configure serial communications for 9600,N,8,1 and no flow

control.

5. Connect the (QSFP) LAG cables between the switches, by connecting port 48 on switch 1 to port

48 on switch2 and port 52 on switch 1 to port 52 on switch 2. See this configuration in Figure 1.

2.2

Note: The following commands will delete all configuration settings.

FTOS>enable

FTOS#delete startup-config

Proceed to delete startup-config [confirm yes/no]yes

FTOS#reload

System configuration has been modified. Save? [yes/no]no

Proceed with reload [confirm yes/no]yes

Note: The switch will reboot.

2.3

FTOS>enable

After the startup configuration is deleted, the factory default Enable mode password is force10.

FTOS>#config

FTOS(conf)#interface ManagementEthernet 0/0

FTOS(conf-if-ma-0/0)#no shutdown

FTOS(conf-if-ma-0/0)#ip address ipaddress mask

FTOS(conf-if-ma-0/0)#exit

SCG1000 | Dell Networking S4810 and Force10 S4810 Configuration Guide for EqualLogic SANs