Dell Networking S5000 Instrukcja instalacji - Strona 23

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik Dell Networking S5000. Dell Networking S5000 50 stron. Data center switch
Również dla Dell Networking S5000: Podręcznik konfiguracji (12 strony), Podręcznik konfiguracji (17 strony), Podręcznik dla początkujących (37 strony)

Figure 9. Slide the mounting brackets

1. Utility side of the chassis

2. Mounting Bracket

3. Holding Bracket (factory installed)

Rack Mounting Safety Considerations

You may either place the switch on the rack shelf or mount the switch directly into a 19" wide, EIA-310-E- compliant rack.

•

Rack loading — Overloading or uneven loading of racks may result in shelf or rack failure, which may damage

equipment and cause possible personal injury. Stabilize racks in a permanent location before loading begins.

Mount the components beginning at the bottom of the rack, then work to the top. Do not exceed your rack load

rating.

•

Power considerations — Connect only to the power source specified on the unit. When multiple electrical

components are installed in a rack, ensure that the total component power ratings do not exceed the circuit

capabilities. Overloaded power sources and extension cords present fire and shock hazards.

•

Elevated ambient temperature — If installed in a closed rack assembly, the operating temperature of the rack

environment may be greater than the room ambient temperature. Use care not to exceed the 40°C maximum

ambient temperature of the switch.

•

Reduced air flow — Install the equipment in the rack so that the amount of airflow required for safe operation of

the equipment is not compromised.

•

Reverse air flow — Necessary clearance is required to ensure cool air intake and to avoid hot air blow out from

I/O panel.

•

Reliable earthing — Maintain reliable earthing of rack-mounted equipment. Pay particular attention to the

supply connections other than the direct connections to the branch circuit; for example, use of power strips.

•

Do not mount the equipment with the Utility panel facing in the downward position.

WARNING: These instructions are a condensed reference. Read the safety instructions in your Safety,

Environmental, and Regulatory information booklet before you begin.

NOTE: The illustrations in this document are not intended to represent a specific switch.