3 Day Blinds MINI BLINDS Classic Skrócona instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Rolety okienne 3 Day Blinds MINI BLINDS Classic. 3 Day Blinds MINI BLINDS Classic 6 stron.

Drukuj stronę

BLIND OPERATION

To lower the blind, pull the lift cords down and toward the
center of the blind and allow the cords to slide slowly through
your hand.
To tilt the slats, twist the tilt wand.
Do not attempt to raise or lower the blind unless the slats are
in a completely open (horizontal) position.
To raise the blind, pull the lift cords down.
To engage the lock, pull the lift cords down and towards the
outside of the blind.
BLIND REMOVAL
End Mount
Top Mount
Top View Closed
Top View Open
5
| Classic Mini Blinds
• Using a flathead
screwdriver, open the
latches of the brackets.
• Holding on to both
ends of the headrail,
gently pull the blind
forward and out of the
brackets making sure
to unhook the headrail
from the center support
bracket(s), if applicable.
• To remove rail from top
mount brackets move
the lever from the closed
position to the open
position.
OPTIONAL HARDWARE
INSTALLATION
SPACERS
Available for use on windows with a
projected molding. They are
allow the blind to be mounted flush with
the outside edge of any standard window
molding.
Spacers are available by contacting our
Client Care Team at 800-800-2239.
HOLD DOWN BRACKETS
Hold down brackets are used primarily on shades being
mounted to doors or in motor homes. (2 per blind) Hold
Down Brackets are available by contacting our Client Care
Team at 800-800-3329. There is a small hole in the center of
the end cap that is covered by a thin plastic cover. Use the
pin of the hold down bracket to push through the center of
the end cap and it will break through the plastic cover.
• With the blind lowered to its full length, place the pin of
each hold down bracket into the hole in each end of the
bottom rail.
• Using a pencil, mark the mounting surface through the holes
in the hold down bracket. Make sure the hold down brackets
are level and aligned with each other.
• Raise the blind and screw the hold down brackets into the
mounting surface using the screws provided.
• Mount the hold down bracket to the side or back of the
window frame so that the pin lines up with the front hole in
the bottom rail end cap with the blind fully lowered.
Spacers
/
" thick and
3
8
• Lower the shade and
flex the hold down
bracket outward so
that the pin can be
inserted into the hole
in the end cap.