Avvio C192069 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Avvio C192069. Avvio C192069 11 stron. 20 volts cordless inflator

OPERATION

Improperly attached hoses or accessories can become detached under

WARNING:

pressure and cause serious injury. Possible air leaks can cause faulty pressure

readings. Make sure all connections are tightly secured.

If self-locking swi ch is up, turn it down .

Press "ON/Unit" button to read the current tire pressure on the gauge. Press "ON/Unit" button

again to select tire pressure measurement unit from PSI, KPA, BAR, KG/CM.

Press the "+" or"-" button to adjust the preset tire pressure to the required tire pressure.

hold the or button down to adjust working pressure quickly, (set value runs up or down faster)

press the "+"or "-" button briefly to adjust the pre-set working pressure in small steps by 0.05

BAR & KG/CM, or by 1 PSI, 5KPA.

8. Press the On/Off trigger switch to start inflating.

When the pressure reaches the pre-set pressure value, the device will stop inflating.

NOTE: To reset the tire pressure measurement unit, press "ON/Unit" to reselect after setting

preset pressure value.

NOTE: Digital gauge records the preset measurement unit and value of last time operation

NOTE: After the air pump reaches the preset pressure value, the digital gauge will go off after

30 seconds, and the device will shut down automatically.

NOTE: Maximum PSI for this unit is 100PSI.

Air chuck clamp

in unlocked

position

Fig.1

Always leave the hose free of obstructions when the tool is not in use. Overheating could

NOTICE:

occur if the hose is blocked.

ACCESSORIES

The supplied accessories perform a variety of functions. The tapered

smaller pinch valves to inflate small items like children's toys, which usually require the user

to inflate them by blowing air into them. The sport

type of sports ball or any other item that requires an inflation needle.

NOTE: When inflating items of 10 PSI or less, inflate in short bursts and check after each burst

with a calibrated measuring device to determine accurate pressure.

Insert needle into ball valve and inflate.

Remove needle after inflation.

NOTE: Pressure required for most sports balls is too low for accurate reading on tool gauge.

B Air chuck clamp in

locked position

C Valve stem

D Air chuck

E Air hose

F Air chuck clamp

can be used on

needle can be used to inflate any