Dell PowerConnect M8024 Podręcznik konfiguracji - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik konfiguracji dla Przełącznik Dell PowerConnect M8024. Dell PowerConnect M8024 21 stron. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Również dla Dell PowerConnect M8024: Uwaga dotycząca wydania (9 strony), Informacje o wersji (27 strony), Aktualizacja oprogramowania sprzętowego (24 strony)
Drukuj stronę
2.11
Configure port channel for LAG
These commands configure the switch interconnect as a LAG.
console(conf)#interface Port-channel 1
console(conf-if-Po1)#mtu 9216
console(conf-if-Po1)#exit
2.12
Configure SFP+ ports for LAG
These commands assign four 10Gb SFP+ ports to the Port Channel.
console(conf)#interface range Tengigabitethernet 1/0/21-24
console(conf-if)#channel-group 1 mode active
console(conf-if)#exit
console(conf)#exit
2.13
Save configuration
console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
2.14
Configure additional switch
Repeat the commands from section 2 to configure the second switch.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a
non-default VLAN, refer to the documentation for your switch.
9
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs