Dell PowerEdge 2550 Instrukcja instalacji stojaka - Strona 22

Przeglądaj online lub pobierz pdf Instrukcja instalacji stojaka dla Przełącznik Dell PowerEdge 2550. Dell PowerEdge 2550 40 stron. Wake-on-lan (wol) support on dell servers
Również dla Dell PowerEdge 2550: Instrukcja instalacji (26 strony), Instrukcja instalacji (32 strony), Podręcznik konfiguracji (10 strony), Instrukcja aktywacji (32 strony), Instrukcja instalacji (32 strony), Podręcznik (28 strony), Podręcznik (15 strony)

Drukuj stronę
Dell PowerEdge 2550 Instrukcja instalacji stojaka
Place the bracket from the right slide assembly on the threaded studs on the left slide
3
assembly, with the bracket turned 180 degrees so that the mounting flange faces
forward (see Figure 1-12).
Secure each center mount bracket (by its locking nuts and shoulder washer) finger
4
tight on their opposite slide assemblies using the two shoulder washers and two
locking nuts you removed in step 2 (see Figure 1-12).
F i g u r e 1 - 1 2 . P o s i t i o n i n g B r a c k e t s f o r F l u s h - M o u n t I n s t a l l a t i o n
Holding the left slide assembly into position in the two-post rack at the location
5
you marked, adjust the front and rear brackets tightly against the vertical two-post
rack and secure the front and rear center mounting brackets to the rack with
two 12-24 x 0.5-inch pan-head Phillips screws on each back mounting flange.
Perform steps 3 through 6 to install the right slide assembly in the rack.
6
The guide pin on the mounting flange should enter a mounting hole in the rack
7
(see Figure 1-13).
Use a 3/8-inch nut driver to fully tighten the locking nuts on the mounting brackets
8
that were finger tight.
1-16
Rac k I n st allat io n G uide
alignment
holes