Dell PowerEdge 350 Instrukcja instalacji - Strona 19
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik Dell PowerEdge 350. Dell PowerEdge 350 32 stron. Wake-on-lan (wol) support on dell servers
Również dla Dell PowerEdge 350: Aktualizacja informacji o diagnostyce systemu (2 strony), Aktualizacja informacji (30 strony), Instalacja sprzętu (22 strony), Podręcznik (15 strony)
Drukuj stronę
support.dell.com
Before You Begin
Before you begin installing your system in the rack, carefully read "Safety Instruc-
tions," found earlier in this guide.
NOTICE: This rack kit is intended to be installed in a Dell rack by trained
service technicians. If you install the kit in any other rack, be sure that the
rack meets the specifications of American National Standards Institute
(ANSI)/Electronic Industries Association (EIA) standard ANSI/EIA-310-D-92,
International Electrotechnical Commission (IEC) 297, and Deutsche Indus-
trie Norm (DIN) 41494. One rack kit is required for each Dell server,
storage system, or appliance that is installed in a rack.
Recommended Tools and Supplies
You need the following tools and supplies to install the system in a four-post rack
cabinet:
•
A #2 Phillips screwdriver
•
A flat-blade screwdriver
•
Masking tape or a felt-tip pen, for use in marking the mounting holes to be used
Installing the Rack Kit
NOTES: If you purchased a Dell rack along with your system, the slide assemblies
may be preinstalled in the rack.
For instructions on installing the system itself, see "Installing the System in the Four-
Post Rack" found later in this guide.
To install the slide assemblies in the rack, perform the following steps:
1.
Remove the rack's front and back doors.
2.
Install the slide assemblies in the rack.
The subsections that follow include instructions for performing these tasks.
Rack Installation Guide
1-13