Dell PowerEdge M420 Podręcznik - Strona 24

Przeglądaj online lub pobierz pdf Podręcznik dla Przełącznik Dell PowerEdge M420. Dell PowerEdge M420 38 stron. Dell poweredge blade servers getting started guide
Również dla Dell PowerEdge M420: Aktualizacja informacji (38 strony), Informacje o wersji (27 strony), Podręcznik (25 strony), Podręcznik użytkownika (23 strony), Podręcznik zawierający ważne informacje (35 strony), Aktualizacja instrukcji (32 strony), Aktualizacja instrukcji (28 strony), Podręcznik użytkownika (26 strony), Podręcznik użytkownika (22 strony), Podręcznik dla początkujących (12 strony), Podręcznik techniczny (46 strony), Podręcznik techniczny (48 strony), Podręcznik portfolio (27 strony), Podręcznik dla początkujących (14 strony), Podręcznik dla początkujących (12 strony)

Improving NFS Performance on HPC Clusters with Dell Fluid Cache for DAS

Figure 13 shows that on a cold-cache read for the random tests, peak IOPS of the DFC configurations

drop from ~123,000 IOPs to ~80,000 IOPs. Interestingly this is higher than the baseline IOPs of ~9,300,

and explained below.

Figure 14 helps explain why the cold-cache read behavior is different for sequential and random I/O. It

uses the output of fldcstat, a utility provided by DFC that displays statistics for the DFC

configuration.

8000

6000

4000

2000

-2000

-4000

-6000

-8000

-10000

Random Reads-coldcache

One piece of information provided by fldcstat is CacheIO-DiskIO. This shows the number of bytes

read and written to the cache device minus the number of bytes read and written to the disk. A

positive value shows IO activity is being served mostly by the cache while, a negative value indicates

more disk IO is being performed than cache IO.

Figure 14 plots CacheIO-DiskIO over the duration of the cold-cache sequential read and random read

tests for the 64 concurrent client test case. From the figure it is seen that during sequential reads

there is a lot of disk IO followed by cache IO. This pattern repeats for the duration of the test. Data is

pulled from the backend disk to the SSDs, served from the SSD, and this cycle is repeated. However for

the random read tests, there is backend disk IO at the start, but the cache quickly warms up and

subsequent read requests are satisfied directly from the cache. This helps explain why cold-cache

sequential reads have low throughput—lower than the DFC-WB configuration, and also lower than the

baseline. Cold-cache random reads do take a hit in IOPS compared to the DFC-WB configuration but,

due to the nature of the small I/O block size (4k) and the longer duration of the test itself, show

significantly better performance than the baseline since the DFC cache warms up very quickly.

Figure 14.

CacheIO-DiskIO on cold-cache reads

fldcstat - CacheIO-DiskIO

Sequential Reads-coldcache