Entec EW-4200D Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przenośny generator Entec EW-4200D. Entec EW-4200D 19 stron. Marine diesel generators

Periodic Maintenance

EW-4200D

For best engine life, the oil should be changed every 75 to 100

hours, or annually, which ever occurs first.

The unit comes with a dipstick type oil pump for changing the

oil. Start and run the engine for several minutes to get the oil

warm. Stop the engine and remove the Dipstick. Insert the oil

Dipstick Pump tube as deep into the engine as possible. Suck the

oil out using the pump, and dispose of it according to EPA

regulations.

Dipstick Oil Pump

Remove the oil Fill Cap and add one quart of approved oil.

Replace the oil Fill Cap and Dipstick. Start the engine and let it

run for one to two minutes. Stop the engine and check the level

on the oil Dipstick. Adjust the level as necessary.

With practice, the amount of old oil removed will be just the

right amount, so that adding one quart of new oil will bring the

level up to the correct level.

Dipstick

Oil Fill Cap

Although there is an oil Drain Plug on the engine (3/15), it is too

low on the generator to provide easy access for draining.

Installation of an adapter at this location for drain pumps, etc.

will automatically void the warranty.

Drain Plug – DO NOT USE!

The Air Cleaner housing contains a dry element filter. Remove it

and shake the accumulated dirt from it each time you change the

oil. The element should be replaced every 250 to 300 hours.

Air Cleaner Element

Entec West, Inc.

16710 SW 72nd • Portland, Oregon 97224 • (503) 624-7118