Dell S6010-ON Informacje o wersji oprogramowania sprzętowego - Strona 6
Przeglądaj online lub pobierz pdf Informacje o wersji oprogramowania sprzętowego dla Przełącznik Dell S6010-ON. Dell S6010-ON 12 stron.
Również dla Dell S6010-ON: Instrukcja instalacji (46 strony)
Drukuj stronę
Direct attach cables (DACs)
CAUTION:
When removing optics with direct attach cables (DACs) from the port, pull the release tab firmly and
steadily. If you have difficulties pulling out the cable, gently push the optic into the port with one hand while at
the same time pulling the release tab slightly upwards—towards the cable/module center—with the other hand.
Do not jerk or tug repeatedly on the tab.
IP address assignment in ONIE
By default, DHCP is enabled in ONIE. If your network has DHCP configured, ONIE gets the valid IP address for the management
port using DHCP, as shown.
Info: Using eth0 MAC address: 64:00:6a:ed:06:ad
Info: Using eth1 MAC address: 64:00:6a:ed:06:ae
Info: eth0: Checking link... up.
Info: Trying DHCPv4 on interface: eth0
ONIE: Using DHCPv4 addr: eth0: xx.xx.xxx.xx / xxx.xxx.xxx.x
You can manually assign an IP address.
1. Wait for ONIE to complete a DHCP timeout and return to the prompt.
2. Wait for ONIE to assign a random default IP address. This address may not be valid for your network.
3. Enter the ifconfig command to assign a valid IP address.
** Rescue Mode Enabled ** ONIE:/ #
ONIE:/ #
ifconfig eth0 xx.xx.xxx.xxx/xx
ONIE-based firmware update process
NOTE:
Always update the ONIE operating system first. After this update finishes, update the firmware, such as the BIOS,
CPLD, FPGA, and so forth.
NOTE:
The output examples are for reference only. Your output may vary.
You can update the firmware by using any of the following methods:
● Firmware update invoked manually from ONIE
● Firmware update using the USB
● Firmware update staging from NOS
● Firmware update staging from ONIE
WARNING:
Do not power cycle or power off your switch when you upgrade the CPLD image.
WARNING:
The FW-updater program updates the switch as needed.
NOTE:
Upgrading the CPLD may take up to 10 minutes.
NOTE:
After you have successfully upgraded, the FW-updater program power-cycles the switch.
Firmware update invoked manually from ONIE
Manually invoke the firmware update from the ONIE prompt using the onie-self-update command.
NOTE:
This method allows you to update the firmware components, for example BIOS and CPLD, in one step without
requiring a switch reboot. However, this method is not support for platforms supporting the multistage reboot sequence.
There are two ways to use the onie-self-update command. For ease of use, Dell Technologies recommends using Option 1.
6