Dell Z9100-ON Instrukcja instalacji - Strona 26

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik Dell Z9100-ON. Dell Z9100-ON 43 stron. Open networking
Również dla Dell Z9100-ON: Instrukcja instalacji (45 strony), Instrukcja instalacji (45 strony)

Drukuj stronę

If you have a redundant PSU (a second PSU), repeat steps 1 through 4 above using the second PSU

slot on the Z9100-ON system.

NOTE: The Z9100-ON powers up when the cables are connected between the power supply

and the power source.

Replacing an AC or DC Power Supply

To replace an AC or DC power supply, follow these steps:

CAUTION: Disconnect the power cord before removing the power supplies. Also, disconnect all

power cords before servicing.

NOTE: The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may

damage the PSU or the Z9100–ON chassis.

NOTE: If a PSU fails, you must replace the entire unit. There are no field serviceable components in

the PSU. To request a hardware replacement, see

NOTE: If you use a single PSU, install a blank plate in the other PSU slot. If you are only using one

power supply, Dell recommends installing the power supply in the first slot (PSU1) and installing a

blank plate in the second slot (PSU2).

Disconnect the power cable from the PSU.

Use the grab handle to slide the PSU out of the power supply bay.

Use the grab handle on the replacement PSU to slide it into the power supply bay.

Attach the power cord to the replacement PSU.

NOTE: The system powers up when the cables are connected between the power supply and

the power source.

Technical

Support.

Power Supplies