Dell M5200 Podręcznik uzupełniający

Przeglądaj online lub pobierz pdf Podręcznik uzupełniający dla Drukarka Dell M5200. Dell M5200 2 stron. Maintenance kit installation instructions
Również dla Dell M5200: Skrócona instrukcja obsługi (2 strony)

Drukuj stronę

Maintenance Kit Installation Instructions

Turn off printer, unplug, and allow it to sit for 30 minutes before performing any of these maintenance procedures.

Duty Cycle: 300,000 Pages @ 5% Coverage

Fuser Removal & Installation:

1. Remove any output options.

2. If a duplex unit is installed, remove the printer from it by using the handholds.

This may require two people.

3. Remove the fuser cover. (If you have a label printer, lift up and remove the

fuser cleaner.)

4. Open the rear access door slightly and pull up at a slight angle to remove.

5. Loosen the two screws on the redrive unit; remove the redrive unit by

pulling outward by the tabs.

6. Loosen the two screws on the fuser asm and pull the fuser from the

printer; to do so, pull the fuser by the metal tab.

7. Install the new fuser in reverse fashion.

Do not touch the new transfer roller or charge roller with your bare hands; oils from skin on

Transfer Roller Replacement:

1. Turn the printer around so the front is facing you; open the front doors

and remove the print cartridge.

2. Unsnap the Transfer Roller Assembly from the left pivot arm.

3. Lift the Transfer Roller Assembly toward the left and remove it from the printer.

4. Leave the protective wrapper on the transfer roller and insert into the

bearing on the right. Then snap the left end of the roller into position.

5. Remove the protective wrapper from the roller and discard.

Charge Roller Replacement:

1. Locate the charge roller toward the rear of the opening, grasp it with your left hand and push the right mounting bracket

away until the charge roller drops out.

The following parts are included in your Maintenance Kit

Description

Fuser

Transfer Roller

Charge Roller

Pick Rolls

* * * AT T E N T I O N * * *

the transfer roller can cause print quality defects.

Dell M5200

Dell RO238

Part Number

M1896

N1497

J1756

M1546

****CAUTION****