Dell 3100cn - Color Laser Printer Instrukcja konfiguracji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Wszystko w jednej drukarce Dell 3100cn - Color Laser Printer. Dell 3100cn - Color Laser Printer 2 stron. Dell printer user manual

Drukuj stronę

NOTICE: After installing the drum cartridge, the printer makes an adjust-

ment for about one to two minutes. Do not turn off the printer during this

time.

With the lever in the upright position, hold the drum cartridge by the handle, align the arrows on the drum cartridge with the

corresponding arrows on the printer and guide the cartridge in until it snaps into place. Pull down the lever on the right to lock

the drum cartridge in place. Close the top cover and then the front door.

Slide the width guides to the edge of the tray. The width

guides should be fully extended. Squeeze the length

guide and slide it to the edge of the tray.

Insert your Drivers and Utilities CD .

Managing Your Printer From the Web |

Managing your printer from the web is only available if your printer is connected to a network.

Network printing is even easier with the Dell P P rinter C C onfiguration W W ebTool.

After proper configuration, the E-M M ail A A lert S S etup feature emails you when toner and paper supplies are running low, or when

the printer needs attention. The Copy P P rinter S S ettings feature lets you quickly and easily copy your 3100cn printer's settings to

another printer. To launch the Dell P P rinter C C onfiguration W W eb T T ool, type your network printer IP address in your Web browser. If

you don't know your printer IP address, print a Printer Settings page.

For more information on managing your printer from the web, see your User's Guide.

If the IP address shows 0.0.0.0 under the TCP/IP heading, you need to assign an address to the printer.

See your Owner's Manual for instructions.

Screen image example from the 3100cn

Printed in China /

T6131A00

Connect your printer to a computer or network.

Load the paper in the tray, making sure the paper does

Insert the tray.

not go above the maximum fill line. Slide the width and

length guides against the edge of the paper.

Run the Dell installation software. See your Owner's Manual for net-

work installation instructions.

When using a USB cable

On the operator panel, press the up/down arrow buttons,

if necessary, to change the size and type of paper loaded

in your printer. When you find the correct size/type,

press

When the New Hardware Wizard screens appear, click Next on all

screens. Then click Finish on the last screen.

When using an Ethernet cable

When using a parallel cable

When you do not use the optional tray with the Dell Laser

Printer 3000cn, load the paper in the multipurpose feeder.

Complete the Dell installation software setup. When the

Congratulations! screen appears, click Print T T est P P age to print a test

page or click Finish to exit.

Click Cancel on any New Hardware screens if they

appear.

Before printing a document, make sure the paper

extender is fully extended.

If you purchased any of the following options, refer to the User's Guide

for installation instructions.

• Optional tray (250-sheet tray module or 500-sheet tray module)

• Duplex module

• Multi protocol card (for the 3100cn only)