AVYCON AVK P2500 Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Klawiatura AVYCON AVK P2500. AVYCON AVK P2500 8 stron. Keyboard controller

 Then, a user should be able to operate the Speed Dome camera directly with AVK-P2500 .

NOTE

 Please check Protocol and Baud rate before operating the Speed Dome Camera using AVK-P2500 .

11.5.3.2 Buttons



(PRESET): Press number Key and PRESET then the camera will move to designated point.

(PATTERN): Press number Key and PATTERN then the designated Pattern will run



(AUTO): Press number Key and AUTO then the designated Auto will run.



(TOUR): Press number Key and TOUR then the designated Tour will run.

(SCAN): Press number Key and SCAN then the designated Scan will run.



(HOLD): Press HOLD to lock the Keyboard. To unlock a user has to input Password. (Default password is 0000)



: Press NEAR/FAR to adjust the focus of Speed Dome camera.



: Press TELE/WIDE to adjust the zoom of Speed Dome camera.

NOTE

 SPD Control Mode is only supported when Speed Dome Camera is directly connected to AVK-P2500 .

WARNING

 DEPENDING ON THE PROTOCOL BEING USED BY THE SPEED DOME CAMERA, CONTROLLING CAMERA MENU

COULD BE DIFFERENT. PLEASE CHECK SPEED DOME CAMERA MANUAL.

NOTE



When a Key does not Work after Set up

If the communication speed of DVR and CP are not co-related, it may not work. Please make sure the Baud rate of Keyboard sets on

9.6kbps.

Press the button to enter PTZ mode and switch to DVR mode again.

Please reboot the DVR.



When Tx Blinks Continually on the LED Window

If Tx blinks continually without any operation, it may be caused by improper set up of Joystick.

OFFSET of the Joystick may not appropriately set up.

Please do Joystick calibration.