30 Second Smile TB100 Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Elektryczna szczoteczka do zębów 30 Second Smile TB100. 30 Second Smile TB100 10 stron. 30 second smiletoothbrush

Drukuj stronę

tongue sCRaPeR

The tongue scraper removes plaque build-up on tongue and will give you fresher

breath.

to use: Depress scraper at back of tongue, apply light pressure onto tongue and

draw outward to remove plaque.

Rinse scraper frequently.

Cleaning YouR bRusH

While brush is on, rinse brush head under hot running water after each use and be

sure all toothpaste is removed. Periodically clean handle with a damp cloth. Take

care not to allow ANY water to enter the battery compartment. If the brush fails to

operate due to corrosion in the battery compartment, the warranty is void.

tRoublesHooting FaQ

- Problem: Brush head plastic hits my teeth.

- solution: You are not using the brush according to instructions. Refer to

"Secrets to Perfect Teeth & Gums" instructional DVD and the manual's

Brushing Instructions.

- Problem: Brush won't operate.

- solution: Batteries are dead. Replace batteries OR Check battery polarity

(- and +). See battery installation instructions, OR make sure that the

switch is fully rotated to the ON position, OR there may be corrosion

inside the battery compartment. Contact customer service if problem

persists.

- Problem: My gums are sore after using the 30 Second Smile

- solution: Some soreness is normal as the toothbrush is reaching areas not

previously reached. Continue using the 30 Second Smile

but be sure to use RED bristled brush head for the first several weeks.

- Problem: My gums are bleeding.

- solution: Your 30 Second Smile

™

toothbrush is self-positioning and brushing

areas that have been missed with other toothbrushes. Some bleeding

during the first 3-5 days of use is normal. If bleeding occurs for more

than a week, stop using and contact customer service.

- Problem: Metal pins at the end of handle are not even.

- solution: The tips of the metal pins are never aligned. Depending on where the

brush starts/stops, one pin will always be longer than the other.

- Problem: Brush Head falls off.

- solution: Push brushes all the way onto the metal pins until you feel and hear a

"snap."

- Problem: I cannot remove brush head.

- solution: Depress the release button on brush head completely and pull firmly

on the brush. To avoid this problem in the future, clean the notch in

the metal pins with rubbing alcohol.

™

toothbrush.

™

toothbrush