AW-Lake EDG-2C-12S Instrukcja instalacji, obsługi i konserwacji - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja instalacji, obsługi i konserwacji dla Akcesoria AW-Lake EDG-2C-12S. AW-Lake EDG-2C-12S 18 stron. The edge flow sensor with bluetooth
Drukuj stronę
Proceed by clicking Add New Row and entering in desired K-factor and corrisponding
frequency. Continue doing this until all desired values are in. To Remove a row, click on the
colume to the left of the row and followed by Clear Selected Row button . Remember to click
Set Table after to apply changes.
*Note: there are 10 spots available but not all rows need to be filled in. Put values in desired amount of
rows and leave the rest at 0. *
Bluetooth Settings
Figure 16: Bluetooth Name
In the Setup tab is the option to change the bluetooth
settings. Click Bluetooth settings, which will bring up a
separate bluetooth window (Figure 16). Enter in desired
name of the device and click Set. A success message should
appear, click OK.
Bluetooth Pin
This allows a user to setup a password to access the sensor
via the bluetooth app. To Enable, check the box and enter
in a 4 digit code followed by Set PIn
Upgrading the EDGE
The new EDGE is equiped with a bootloader which means that any updates to the firmware of
the device can be done without sending the device back to the factory.
In the Advance tab at the top left corner of the window will be and option to Upgrade
Mainboard Firmware. After clicking this selection a new window will open (Figure 17).
Figure 17: Firmware Upgrade
15 |
P a g e