EarthQuake Cinenova IR16 Podręcznik użytkownika - Strona 13
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz EarthQuake Cinenova IR16. EarthQuake Cinenova IR16 20 stron. 8-zones multi-source ir driven amplifier
Drukuj stronę
Cin
én
ova-IR16 Power Amplifier
Special Features
Eight individual power supplies:
The Cinénova-IR16 is designed with 8 individual power
supplies(bifilar) for power isolation, accuracy
separation.
Peak LED indicators:
The Cinénova-IR16 is equipped with 16 LED indicators on the
front panel. They show the operating status of each channel; the LEDs
will illuminate when the maximum recommended output is exceeded.
If an LED is illuminated the majority of the time, it indicates that the
corresponding channel is over-driven (clipped). The input to the
channel must be reduced to eliminate distortion and eventually,
damages to the amplifier.
Thermal protection:
Each channel is equipped with a thermal sensor designed to
shut the amplifier down when it overheats. Overheating is not typical. It
only occurs if the amplifier is over driven with low impedance speakers,
or if the amplifier is located in an improperly ventilated space.
Individually selected and matched components:
Components used to construct the Cinénova-IR16 are
subjected to an exhaustive selection process; during which, the
components are matched and individually tested to exact tolerance.
The multi-layer, glass-epoxy, double sided printed circuit boards
exceed the standard stringent requirements by 50%.
8-Zones:
The Cinénova-IR16 delivers up to 8-zones, and several other
room combinations to better suite the your needs.
Rack mountable:
and better channel
used racks.
110V AC and 220V AC selectable:
it can also be set to accommodate 220-240VAC by Earthquake
authorized technician(s)/dealer(s).
Remote zone control:
IR remote control. Each remote has the ability to control volume's
up/down level, mute and also repeat the IR signal to other sources.
Bus input:
channels for one source. Simply plug the input source RCAs into the
BUS input on the unit. Then switch the input source selector to BUS for
as many channels are connected to the corresponding input source.
Bridgeable function (minimum impedance = 4-ohm):
into several different configurations for higher power rooms.
4 or 8-ohm compatible:
impedance ratings, Earthquake Sound's Cinénova-IR16 amplifier is
designed to be 4 and 8-Ohm compatible.
13
This amplifier is designed to conveniently mount in commonly
The Cinénova-IR16 is factory preset to 110-120VAC. However,
Each of the eight possible zones can be controlled by a wireless
This feature simplifies installation by consolidating several
The Cinénova-IR16 delivers up to 8-zones, and can be bridged
Since speakers are manufactured in several different
Special Features