EarthQuake 9000E Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt do trawników i ogrodów EarthQuake 9000E. EarthQuake 9000E 12 stron. Power earth auger
Również dla EarthQuake 9000E: Instrukcja obsługi (12 strony)
Et
SERVICE: TROUBI1ESHOOTIN6 AND REPAIR
TROUBLESHOOTING
A
CAUTION
Practice safety at all times. Engine must
be turned off and allowed to cool, and
spark plug wire must be disconnected
before attempting any maintenance or
repair.
Problem
Possible cause
Remedy/Action
Engine will not start
1. Power switch off
1. Flip switch to on position
2. Spark plug wire disconnected
2. Connect spark plug wire to spark plug
Engine runs rough. floods during operation
I. Dirty air cleaner
1. Clean or replace air cleaner
Choke partially engaged
2. Turn off choke
Carburetor out of adjustment
3. Call factory
Engine is hard to start
•
I. Stale fuel
I. Drain old fuel and replace with fresh. Use
gas stabilizer at end of season
Spark plug wire loose
2. Make sure spark wire is securely attached
to spark plug
Dirty carburetor
3. Clean carburetor, use gas stabilizer, new
gas can
Engine misses or lacks power
I. Clogged fuel tank
Clogged air cleaner
Improper carburetor adjustment
Spark plug dirty, improper gap. or wrong
type
Remove and clean
Clean or replace
Call factory
Replace spark plug and adjust gap
Auger turns at idle
I. Idle speed too high
1. Adjust idle speed lower
2. Broken clutch spring
2. Replace both springs
Auger turns, but has no power
I Choke on
2 Carburetor out of adjustment
3 Broken transmission
4 Worn clutch shoes
5 Worn engine lower seal
I. Turn off choke after engine is running
Call factory
Call factory
Replace clutch shoes and springs
Call factory
Auger jumps on ice
I. Blades damaged or sharpened incorrectly
I. Buy new blades, or have blades sharpened
at factory
Auger cuts slowly
1. Dull blades,
I. Buy new blades, or have blades sharpened
at factory
2. Damaged point
2. File point
Engine runs, then quits
I. Gas cap not venting
I. Check self venting gas cap
2. Screen in carburetor plugged
2. Clean screen, use gas stabilizer, clean gas
can
Page?