Award PPS602 Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Okap wentylacyjny Award PPS602. Award PPS602 12 stron.
Również dla Award PPS602: Podręcznik (20 strony)

Drukuj stronę

F = AUTOMATIC STOP TIMER - 15 minutes (*)

• If your rangehood does not have the INTENSIVE speed

function, press key E for two seconds and it will be activated

for 10 minutes after which it will return to the previously set

speed. When the function is active the LED flashes. To interrupt

it before the 10 minutes have expired press key E again.

• By pressing key F for two seconds (with the rangehood

switched off) the "clean air" function is activated. This function

switches the rangehood on for ten minutes every hour at the

first speed. As soon as this function is activated the motor

starts up at the first speed for ten minutes, during this time

key F and key C must flash at the same time.

After ten minutes the motor switches off and the LED of key

F remains switched on with a fixed light until the motor starts

up again at the first speed after fifty minutes and keys F and

C start to flash again for ten minutes and so on.

By pressing any key for the exclusion of the rangehood light the

rangehood will return immediately to its normal functioning

(e.g. if key D is pressed the "clean air" function is deactivated

and the motor moves to the 2nd speed straight away. By

pressing key B the function is deactivated).

(*) The "automatic stop timer" delays stopping of the ran-

gehood, which will continue functioning for 15 minutes at

the operating speed set at the time this function is activated.

• Active carbon/grease filter saturation:

- When button A flashes at a frequency of 2 seconds, the

grease filters must be cleaned.

- When button A flashes at a frequency of 0.5 seconds, the

carbon filters must be replaced.

After the clean filter has been replaced, the electronic memory

must be reset by pressing button A for approximately 5 secon-

ds, until the light on the button stops flashing.

• COMMANDS:(Fig.14A)MECHANICAL_(Fig.14B) Elliptic the key

symbols are explained below:

A = LIGHT

B = OFF

C = SPEED I

D = SPEED II

E = SPEED III

G = MOTOR WORKING indicator

THE MANUFACTURER DECLINES ALL RESPONSIBILITY

FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE

ABOVE WARNINGS.

- 9 -