EarthWay 2170 Instrukcja montażu i obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja montażu i obsługi dla Rozrzutnik EarthWay 2170. EarthWay 2170 6 stron. Commercial broadcast spreader with side spread control
Również dla EarthWay 2170: Instrukcja montażu i obsługi (8 strony), Instrukcja obsługi (8 strony), Instrukcja montażu (12 strony), Instrukcja montażu i obsługi (6 strony), Instrukcja montażu (10 strony)

Slide axle bushing over axle and into axle

bearing to both sides as shown.

Install coast wheel to axle using outside pin hole. As shown, insert 1" cotter pin

through axle (

NOT THRU THE WHEEL

ling out. TURN SPREADER UPRIGHT ON TO WHEELS.

Axle bearing

Axle bushing

Slide Axle

bushing

Install drive wheel to axle using pin hole nearest to lower handles as shown. Insert 2"

cotter pin through wheel and through axle. Bend with pliers to prevent pin from falling

out.

). Bend with pliers to prevent pin from fal-

10.

NOTE: BEFORE INSTALLING GAUGE AND UPPER

HANDLES TO HANDLE SHAFT, UPPER HANDLES FEATURE

THREE POSITIONS FOR OPERATOR'S COMFORT.

tor chooses middle or upper positions, use handle spacer in hole

nearest to handle grips. Insert 1¾" bolt through upper handle

then through handle spacer through other upper

TIGHTEN LOCKNUT YET. TIGHTEN THIS NUT LAST.

gauge & lever using (2) 1¾" bolts. Be sure gauge is on left hand

side. Tighten locknuts to gauge first. TIGHTEN NOW.

11.

Insert pivot rod into shut off plate as shown. Turn to lock in

place. [ N

: E

OTE

XTRA BEND IN ROD END ATTACHES TO THE

SHUT

OFF PLATE

12.

Insert other end of pivot rod into pivot and bracket assembly

as shown. Turn to lock in place.

If opera-

handle. DO NOT

Install

PAGE 3