EarthWay EV-N-SPRED 2150 Instrukcja montażu - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Rozrzutnik EarthWay EV-N-SPRED 2150. EarthWay EV-N-SPRED 2150 9 stron. 50 lb. commercial spreader with side spread control
Również dla EarthWay EV-N-SPRED 2150: Instrukcja montażu i obsługi (6 strony), Instrukcja montażu i obsługi (8 strony)
Drukuj stronę
Assembly and Operation Instructions
HELPFUL HINTS
Read the directions before assembly.
If your spreader does not spread evenly, be sure "FRONT" on the GEARBOX points to the front of the spreader. The
impeller must turn clockwise when pushing forward. Reversing the GEARBOX during assembly will cause issues.
Your spreader is calibrated for three miles per hour, which is a brisk walking speed. Slower or faster speeds will
change the spread pattern. Wet fertilizer will also change the spread pattern and flow rate. Do not use powdered
materials as it will damage the gearbox.
Gears are permanently lubricated at the factory. Do not open the GEARBOX or dirt may enter.
SPREADER ASSEMBLY INSTRUCTIONS
Remove all components and hardware items
Step 1:
from the box. Place the spreader hopper upside down
and facing away from yourself.
Install FRAME using (4) #14 x 1½" Flat Head
Step 2:
Phillips screws. TIGHTEN THESE NOW
Install impeller onto pinion shaft by pressing
Step 3:
the impeller as shown onto the pinion shaft and turning
the impeller while holding the pinion shaft to engage
with the COIN fully, and press down to secure.
Next, insert Cross Brace thru the Gearbox Brace as shown
above.
2150_M51257_RevJune2021_new
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7
PAGE 2