EarthWay EV-N-Spred C22HDS Instrukcja montażu i obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja montażu i obsługi dla Rozrzutnik EarthWay EV-N-Spred C22HDS. EarthWay EV-N-Spred C22HDS 6 stron. Broadcast spreader
Również dla EarthWay EV-N-Spred C22HDS: Instrukcja montażu i obsługi (8 strony), Instrukcja montażu i obsługi (6 strony)
Drukuj stronę
s
3
tep
10. NOTE: Before installing the Gauge & Lever
assembly and the Upper Handle, select the
best Upper Handle position for the operator's
comfort. You can select lower, middle, or upper
positions for best fit to the operator's height.
Insert 2 ¾" bolt through the Gauge, then Upper
Handle and finally through Handle Shaft. See
example below.
TIGHTEN NOW
3 Position Handle
Lower Position
Middle Position
Upper Position
1/4-20
Lock Nut
and
cupped washer
11. Install flattened end of control rod in to lever on gauge into Control Rod Tabbed hole as
shown to the right. Turn to lock in place.
NEXT: Install (1) 1/4-20 Regular Hex Nut [not a locknut] on to Control Rod and thread
halfway as shown above.
12. Next push lever forward to setting "0". Align control rod with hole in pivot bracket, pull lever backward to insert
control rod through hole in pivot bracket. [TIP: If the lever does not move easily, loosen Lever Tension Nut slightly to
make this step easier] Now install 1/4-20 Regular Hex nut on to Control rod.
CALIBRATION
13. Pull lever back to setting "30" as shown. Next push pivot & bracket forward so that the shut off plate in the
hopper is in the full open position. [NOTE: THE SETTING OF "30" ON THE GAUGE & LEVER ASSEMBLY MUST
OPEN THE SHUT-OFF COMPLETELY FOR PROPER CALIBRATION.]
Now tighten the nuts against the Pivot Bracket Angle to prevent change in calibration. Test by opening and closing the
Gauge & Lever a few times to ensure an accurate calibration.
14. Tension on the flow control lever may be adjusted by tightening or loosening the tension nut as shown on the right.
15. Insert Agitator to pinion shaft on inside of hopper. NOTE: Position of flat
side of agitator. This Agitator should be installed as shown at the right.
PAGE 4
Slide Upper
Handle on to
Handle shafts
1/4-20 x 2-3/4"
Hex Head Bolt
DO NOT TIGHTEN NUTS YET.
1/4-20 X 1-1/2"
Hex Head Bolt
and cupped washer
1/4-20
Insert Control Rod
Lock Nut
and cupped
washer
CALIBRATION POINT
Attach 1/4-20 Regular
Hex Nuts
at these points.
Notice the position
of the double bend point.
Gauge & Lever
Lever Tension Nut
30
into
Pivot Bracket
Control Rod
Tabbed Hole
Control Rod