Allied wagner 591004 Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Ekran dotykowy Allied wagner 591004. Allied wagner 591004 10 stron. Vehicle monitor kit

12"

to mount the monitor. Use a 11/64" drill for pilot

holes.

10. Mount the antenna on a flat surface, in a location

on the machine with nothing above it (a clear view

to the sky), and no obstructions within 12" laterally

of the antenna. See Figure 5.

11. Alternatively, the magnet may be removed, and

the bracket bolted directly to a surface.

CAUTION

Never alter a ROPS structure in any way.

If the antenna is to be mounted on top of

the ROPS structure as shown above, the

magnet mount MUST be used.

12. Route the antenna cables inside the cab, to the

vehicle monitor. Connect the CELLULAR and GPS

cables to the vehicle monitor as shown in Figure

13. Route wire harness 590970 from the vehicle mon-

itor (do not plug in yet) to the terminals previously

identified as "E", "F", and "G" in Figure 2. The wire

80-1056

Rev: 8-2014

Figure 5 Antenna Mounting (Chipdozer)

14. Strip 5/16" of the insulation from the individual

15. Route wire harness 591014 from the vehicle mon-

16. Strip 5/16" of the insulation from the individual

harness may be cut to length, but do not cut too

short.

wires on wire harness 590970. Connect to termi-

nals "E", "F", and "G" as shown in Figure 2. Do not

connect the plug end to the vehicle monitor yet.

itor (do not plug in yet) to the terminals previously

identified as "A", "B", "C", and "D" in Figure 2. The

wire harness may be cut to length, but do not cut

too short.

wires on wire harness 591014. Connect to termi-

nals "A", "B", "C", and "D" as shown in Figure 2.

Note that the green and blue wires are not used,

and should be folded back and taped. Do not

connect the plug end of the harness to the vehicle

monitor yet.

CAUTION