Alligetter ACS300 Karta informacyjna produktu

Przeglądaj online lub pobierz pdf Karta informacyjna produktu dla Narzędzia Alligetter ACS300. Alligetter ACS300 2 stron.

Drukuj stronę

INSTRUCTIONS

The Alligetter™ is designed to retrieve items that have fallen into the garbage

disposal, though it is not limited to this one task. When used with a disposal, a

device to spread the rubber flaps has been included.

ASSEMBLY AND USE OF FLAP SPREADER

1. Assemble flap spreader by inserting the tap into the hole as shown in

diagram 1.

2. Some disposals don't have rubber flaps so the flap spreader would not be

needed in this case.

3. Some disposals have removable flaps which gives the user the option of

removing the flaps or using the flap-spreader to gain access to the disposal.

4. The flap spreader has several size options depending on if you have

removable flaps or not. Use whichever hole size works best for your disposal.

Note: View and access are limited if removable flaps are not taken out when

using the Alligetter™.

USE AND CARE OF THE ALLIGETTER™

Step 1

Insert flap spreader, as shown in diagram 2, deep enough to seat the unit. In

most cases the tabs that stick out from the flap spreader will contact the rubber

flaps or sink indicating proper depth.

Step 2

In the stored position, the Alligetter's™ handle is folded shut and the light is off. Unfold the handle

by gently pulling and rotating it away form the main body of the Alligetter™ until the handle clicks

into the locked position. Lightly press and release the button on the back of the battery pack to turn

the light on. Grasp the Alligetter™ with a finger in the trigger loop, insert the tip into the disposal

and search for the item that needs removing. Once the item has been found simply grasp it by

pulling the trigger and allowing the jaws to close on the item. Repositioning items using the

Alligetter™ tip can make grabbing difficult things easy.

Step 3

After removing the foreign object from the disposal grasp the handles of the flap spreader and lift

straight up to remove.

Step 4

Most of the time the tip can simply be rinsed under warm water and then stored ( Step 6).

Step 5 (optional-to be used if the tip requires cleaning)

If the tip is dirty and requires cleaning, the light needs to be removed, as shown

in light removal diagram 3. To remove the light simply pull the battery pack off of

its holder and continue to pull until all of the cord connecting the battery pack with

the LED in the tip is out of the groove. Then pull on the rear part of the LED holder

that is attached to the other end of the white cord rotating it forward and once the

rear is separated from the main body simply pull light up and out. Now that the

light is out, the unit can be cleaned using a brush and soap. Once the Alligetter™

is rinsed and dried the light can be reattached by inserting the LED end of the light

holder into the opening, slide light towards tip and push rear down until the light

holder is clipped in. Now press the white connecting cord into the groove and

snap the battery pack back into its holder on top of the Alligetter.™

PRODUCT INFORMATION SHEET

Diagram 1

Diagram 2

Diagram 3