Miele PG 8172 ECO Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Miele PG 8172 ECO. Miele PG 8172 ECO 42 stron. Commercial dishwashers

Miele PG 8172 ECO Instrukcja obsługi

Before working with the machine

3
Before working with the machine
 Have the machine set up by an authorised service technician or your dealer ( 15).
 Have the machine connected as per the locally applicable standards and the regulations of the authorised
mechanics (water, waste water, electrical system) ( 16 and 17).
 After connecting the water and the power properly, contact the relevant Miele Service Department or your
dealer for the commissioning of the machine and for providing training in its operation. Have yourself and
your operating personnel trained in the operation of the machine.
4

Product description

4.1 Mode of operation

The boiler and the tank fill and are warmed up to the operating temperature after the machine is switched on.
During the heating phase, the lighting of the start button (3) changes gradually from red to green. When the
target temperatures are reached, the machine is ready for use. The start button lights up green.
The machine is fully automatic with programmes consisting of three steps: Wash, Drain and Rinse. While a
wash programme is running, the start button gradually changes from blue to green.

4.2 Special equipment

The following special equipment is available:
 PG 8172 ECO (model)
The construction above the machine has a fan motor and a heat exchanger. After rinsing, the fan motor
draws the steam and vapours (= exhaust air) out of the interior through the heat exchanger. The cold
fresh water flowing through the heat exchanger condenses the vapours and is preheated for the rinsing of
the next wash programme. Less energy is therefore required to heat the fresh water to the recommended
rinse temperature. A waste water heat exchanger provides an additional energy gain. This system also
sustainably improves the kitchen climate because when you open the hood there are less vapours from
the machine.
Requirement: Connect the machine to the cold water.
 Automatic hood opening (special accessory to be installed by the service technician)
The hood opens automatically after each wash cycle.
 Internal water softener ( 6)
44