Allmatic ARGO 1 Series Podręcznik - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik dla Jednostka sterująca Allmatic ARGO 1 Series. Allmatic ARGO 1 Series 9 stron. Switchboards, programmable for 1 or 2 motors with independent slowdown control
1 2
3
4 5 6 7
8
9 10
FC 1
Limit switch 1 and 2 placed
for slowdown in opening
7.7.2 Model ARGO1: If limit switches are installed, these operate in the following ways:
1 2
3
4 5 6 7
1 2
3
4 5 6 7
1 2
3
4 5 6 7
1 2
3
4 5 6 7
7.8 Symmetrical / asymmetrical opening (ONLY FOR ARGO 2 MOTORS ).
1 2
3
4 5 6 7
8
9 10
1 2
3
4 5 6 7
8
9 10
Mechanical stop
opening
Anta B
Symmetrical opening.
Esemp io di funzionamento simmet rico:
Opening time door A = opening time door B
Tempo di apertura anta A = Tempo di apertura anta B
7.9. Immediately re-closing after photocells intervention.
This selection provides to closing the gate after an interruption of photocells beam. If a break time was estimated, the countdown is stopped and the
gate closes.
1 2
3
4 5 6 7
8
9 10
1 2
3
4 5 6 7
8
9 10
6-1622192
rev. 14
21/09/2012
Type of limit switch Function
ON
OFF
Opening limit switch
Limit switch 1 and 2
positioned in closing
FC 2
Conceptual diagram of
limit switch functions
ON
OFF
8 9 10
ON
OFF
8 9 10
ON
OFF
8 9 10
ON
OFF
8 9 10
ON
With dip-switch in this position, the gate opens/closes symmetrically (one operational time for both wings to
OFF
set using the "WORKING time" trimmer).
With dip-switch in this position, the gate opens/closes asymmetrically (different operational time for the two
ON
wings to set respectively with the "WORKING TIME" e "2nd: WING D" trimmers).
OFF
Mechanical stop
closing
Anta A
ON
OFF
Re-closing after a stop in photocells beam disabled.
ON
Re-closing after a break in photocells beam enabled.
OFF
No operation
Start of slowdown
In closing
Type of limit switch
Closing limit switch
Closing limit switch
Type of limit switch
Opening limit switch
Opening limit switch
Mechanical stops
opening
Esempi o di fu nzi o namen to asi m met rico:
Asymmetrical situation
Tem po di apert ura an ta B > Tempo d i apertura a nta A
Tem po di apert ura an ta A > Tempo d i apertura a nta B
ITA
ENG
FRA
ESP
DEU
Start of slowdown only in closing: the start of slo-
wdown phase in closing is set off by the intervention of
both limit switches (one for each wing), while it is only
timed in opening (see diagram below).
FC 1
Limit switch 1 and 2 placed
for slowdown in closing
Function
End closing operation
Start of slowdown in closing
Function
End opening operation
Start of slowdown in opening
Mechanical stop
closing
Anta B
Anta A
Opening time door B > opening time door A
Opening time door A > opening time door B
POR
FC 2
Mechanical stops
opening
6/9