Miele DA 3490 EXT Instrukcja obsługi i instalacji - Strona 26

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Okap wentylacyjny Miele DA 3490 EXT. Miele DA 3490 EXT 40 stron.

Installation

Positioning the appliance in

the wall housing unit

To position the appliance correctly,

cut the spacer strip to required depth

T, and then attach it to the back of

the appliance.

T= Depth of carcase K minus depth of

appliance G

^ Example

shows the installation

without a front panel fitted and with

the front edge of the deflector plate

flush with the front edge of the

furniture housing unit. This installation

needs a shelf 95 mm deep.

^ Example

shows the installation

with a front panel to match the

kitchen furniture. This installation

requires dimension b for the front

panel plus 5 mm for the DML 400

fixing kit to be added to the shelf

dimension (95 mm + 5 mm +

dimension b).

The remaining installation gap must be

at least 180 mm in depth.

If it is less than 180 mm, position the

appliance further back, and reduce

measurement T accordingly.

The position of the deflector plate can

be adjusted in depth by a maximum of

35 mm at the front.

^ Cut the spacer strip supplied to

measurement T.

Score along the groove for the

smaller measurement as shown, and

remove the surplus.

^ Screw the spacer strip underneath

the housing unit sides, flush with the

rear wall.

^ Draw a vertical line up both inside

walls of the housing from the front of

the spacer strip.