Miele DA 408 Instrukcja obsługi i instalacji - Strona 28

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Okap wentylacyjny Miele DA 408. Miele DA 408 36 stron. Ventilation system
Również dla Miele DA 408: Instrukcja obsługi i instalacji (36 strony), Wymiary produktu (2 strony), Instrukcje instalacji (1 strony), Instrukcja obsługi i instalacji (36 strony), Instrukcja obsługi i instalacji (36 strony)

Plywood backing

The majority of the weight of the

installed ventilation system will be

supported by the lower retaining

plate. It must be firmly attached to

the stud framing behind the drywall.

If studs are not available in the

required locations, a plywood

backing (min. ½" (13 mm) thick)

spanning at least two studs must be

installed. Failure to adequately

support the weight as stated may

result in the ventilation system falling

off the wall, causing personal injury

and property damage.

(If plywood backing is not needed,

proceed to the included "Installation

dragram".)

To install a plywood backing

^ Determine and mark the location of

the retaining plate for the canopy as

outlined on the "Installation diagram".

^ Make a cutting line 3" (76 mm) above

and 3" (76 mm) below the outline of

the retaining plate.

^ Find the studs to the left and right of

the mounting location by tapping the

wall or using a stud finder.

^ Mark a vertical cutting line along the

center of each stud.

CAUTION

When cutting or drilling into the wall

or ceiling, do not damage electrical

wiring and other hidden utilities.

^ Remove the drywall between the

cutting lines and replace it with

plywood of a matching thickness

(min. ½" (13 mm) thick). Tape the

joints and refinish the wall.

^ Proceed to the enclosed "Installation

diagram" to complete the installation.