Consumer Information and FCC
Requirements
Telephone Connection
•
This equipment complies with Part 68 of the Federal
Communications Commission rules. These rules permit
this device to be directly connected to the telephone
network. Standardized jacks are used for these
connections. This equipment should not be used on party
lines or coin lines.
•
If this device is malfunctioning, it may also cause harm to
the telephone network; this device should be
disconnected until the source of the problem can be
determined and until it has been repaired. If this is not
done, the telephone company may temporarily
disconnect your service.
•
The telephone company may make changes in its
technical operations and procedures. If such changes
affect the compatibility or use of this device, the
telephone company is required to give adequate notice
of the changes.
•
If the telephone company requests information on what
equipment is connected to their lines, inform them of:
a
The telephone number this unit is connected to
b
The ringer equivalence number
c
The USOC jack required: RJ-11C
d
The FCC Registration Number
Items (b) and (c) are indicated on the label. The ringer
equivalence number (REN) is used to determine how
many devices can be connected to your telephone line. In
most areas, the sum of the RENs on any one line should
not exceed five (5.0). If too many devices are attached,
they may not ring properly.
•
In the event of equipment malfunction, the manufacturer
or an authorized repair center should perform all repairs.
It is the responsibility of users requiring service to report
the problem to the manufacturer, or an authorized agent.
Refer to "Where to Get Help" in this document for
contact information.
Statement of Fax Branding
The Consumer Protection Act of 1991 makes it unlawful for
any person to use a computer or other electronic device to
send any message via telephone fax machine, unless it
clearly contains: a margin at the top or bottom of each
transmitted page or on the first page of the transmission, the
date and time it is sent, identification of the business or other
entity, or individual sending the message, the telephone
number of the sending machine or such business, entity,
or individual.
22
ENERGY STAR Compliance
Products marked with the ENERGY
®
STAR
logo on the packaging box
qualify with the U.S. Environmental
Protection Agency's ENERGY STAR
guidelines for energy efficiency.
Products with the ENERGY STAR label are designed to use
less energy, help you save money on utility bills, and help
protect the environment.
®
ENERGY STAR
is a registered trademark owned by the U.S.
government.
Canada Department of Communications
(DOC) Notice
Telephone Connection
The Canada Department of Communications label identifies
certified equipment. This certification means that the
equipment meets certain telecommunications network
protective, operational, and safety requirements. The
department does not guarantee the equipment will operate
to the user's satisfaction.
Before installing this equipment, the user should ensure it is
permissible to connect it to the facilities of the local
communications company. The equipment must be installed
using an acceptable method of connection. In some cases,
the company's inside wiring associated with a single line
individual service may be extended by means of a certified
connector assembly (telephone extension cord). The
customer should be aware that compliance with the above
conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be made by an
authorized Canadian maintenance facility designated by the
supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the
telecommunications company cause to request that the user
disconnect the equipment.
Users should ensure, for their own protection, that the
electrical ground connections of the power utility, telephone
lines, and internal metallic water pipe systems, if present,
are connected together. This precaution may be particularly
important in rural areas.
WARNING: Users should not attempt to make
such connections themselves, but should contact
the appropriate electrical inspection authority or
electrician, as appropriate.