HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER Podręcznik - Strona 15

Przeglądaj online lub pobierz pdf Podręcznik dla Pulpit HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER. HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER 24 stron. Intervideo ã¥â®â¶ã¥âºâã¥â½â±ã©â„¢â¢ ã¥â¿â«ã©â‚¬å¸ã¥â€¦â¥ã©â€”â¨ã¦å’â€¡ã¥ââ€”
Również dla HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER: Podręcznik użytkownika (37 strony), Podręcznik wsparcia (27 strony), Podręcznik (10 strony), Skrócona instrukcja obsługi (8 strony), Podręcznik dla początkujących (2 strony), Ważne informacje (1 strony), Ważne informacje (1 strony), Ważne powiadomienie (1 strony), Podręcznik uzupełniający (1 strony), Podręcznik wsparcia (29 strony), Podręcznik (8 strony)

Replacing a Hard Disk Drive

The hard disk drive of your PC may be located inside

a cage. If it is, follow the first set of instructions,

"To replace a hard disk drive (with a hard disk drive

cage)" on page 11. If your hard disk drive is not

located inside a cage, follow the second set of

instructions, "To replace a hard disk drive (without

a hard disk drive cage)" on page 12.

To replace a hard disk drive

(with a hard disk drive cage)

1 Make sure the release tab on the hard disk drive

bracket is in the unlocked position before you insert

the new hard disk drive.

2 Connect the power and data cables to the back of

the hard disk drive.

Connecting the Serial ATA hard disk drive

cables

WARNING: For Parallel ATA drives,

connect the data IDE cable end labeled

Master to the primary hard disk drive. If

you have a second hard disk drive,

connect the data IDE cable plug labeled

Slave to the second hard disk drive. If the

IDE cable is not connected correctly, the

PC will not be able to locate the hard

disk drives and data may be lost.

Connecting the Parallel ATA hard disk drive

data cable

3 Align the two screws on the top and two screws on

the bottom of the replacement hard disk drive with

the screw head tracks on the top and bottom of the

hard disk drive bracket. Slide the hard disk drive

until it snaps into place (K).

4 Push the release tab on the top of the hard disk

drive bracket into the locked position (L).

5 Complete the procedures to replace the side panel,

and to close the PC. See "Opening and Closing the

PC" on page 1.

Upgrading and Servicing Guide